Check that sources are connected and turned on if there's no sound. Onkyo receivers include an amplifier and broadcast radio receiver, so you can isolate the receiver by setting "Source" to "FM Radio" and try listening for noise.
In this way, how do I reset my Onkyo receiver?
Reset the Receiver
- Press the "Power" button to turn your TX-NR708 receiver on.
- Hold down the "VCR/DVD" button and, with another finger, press the "On/Standby" button. Watch the display. You should see "Clear" appear on the receiver's display before it goes into standby mode. Release the buttons.
Secondly, how long do Onkyo receivers last? ONKYO USA Corporation Limited Consumer Warranty
Receivers | 2 years Parts & Labor |
DVD Players | 2 years Parts & Labor |
CD Players | 1 years Parts & Labor |
Amplifier | 2 years Parts & Labor |
Home Theater Systems | 2 years Parts & Labor |
Herein, how do you troubleshoot a receiver?
How to Fix Stereo Receivers
- Look over the cable connections running into the receiver. Make sure the cables are completely inserted into both the receiver and any connected hardware.
- Look over the fuses on the back of the receiver.
- Open up the CD tray of the stereo receiver.
- Wipe off the air intake vents on the side of the stereo receiver.
How do I test my Onkyo receiver?
Plug the receiver into the wall if the power won't come on. Lights on the front of the unit indicate proper power supply. Check that the wall outlet is functioning if the Onkyo still won't turn on. Plug something else in to the same outlet and see if it works.
Similar Question and The Answer
How do I test my Onkyo receiver speakers?
To setup your receiver to output the test tone from the speakers, press the Setup button and select Speakers>Manual Setup>Level>Test Tone Star. You can now select and adjust the speakers' audio level using the "UP, DWN and SIDES arrows" buttons on your remote control.
What is direct mode on Onkyo?
The "direct" mode means that no sound matrixing is applied. That means that if the source is 5.1, then in direct mode you will get 5.1 just like the source had intended. When you don't use direct, you apply sound processing like Pro Logic IIx or THX Cinema.
Why does my Onkyo receiver click?
Every time the audio signal is interrupted the receiver will click because it has lost the signal, that's just the way Onkyo has designed the circuit. If the HR44 is interrupting the digital output more than your previous device, then it would be worse with it.
How do I enable ARC on Onkyo receiver?
How to Enable ARC LG 47LW550T Onkyo TX-SR608 Press Setup on the Onkyo Remote. Assuming you have OSD enabled, you will see the setup menu on screen. Go to Hardware Setup. Go to HDMI. Set HDMI Control (RIHD) to On. Set Power Control to On. Set TV Control to On. Exit Setup by pressing the Setup button on the Onkyo remote.
Are Onkyo and Pioneer the same company?
Pioneer Electronics announced last week that it would sell its home theater entertainment business to audio equipment maker Onkyo. The Pioneer brand will continue, the AV receivers, Blu-ray players, speakers, etc. aren't going away. Onkyo will follow the same course with its home AV products.
How do I reset my Onkyo Remote?
"Clear" is appeared on the display and the unit will enter standby mode. 2. Press and hold 2Q for 3 or more seconds until the 3 remote indicator stays lit. Within 30 seconds, press 1RECEIVER again.
How do I reset my Onkyo sr373?
Use the front panel controls to do this. Switch the receiver into standby. While holding down STEREO, press and hold ON/STANDBY for about two seconds. When you see RESET? appear in the display, press SURROUND OK? Press DSP to confirm.